The VeEX UX400 100G module, with its physical interfaces for OTU3, 40GE, OTU4, and 100G Ethernet testing, is a suitable complement to the UX400 Platform. The UX400 modular platform offers a full range of link and service testing capabilities for a complete DS1 to OTU4 and 10 Mbps to 100 GE, transport and Carrier Ethernet testing in a single compact unit.
Installation, commissioning, monitoring and maintenance of OTN and Ethernet networks is simplified thanks to a combination of intuitive features and powerful test functions. Using an intuitive interface, fast troubleshooting and comprehensive analysis of transmission problems can be performed. Novice users benefit from the easy-to-use GUI, while experienced users will appreciate an array of advanced features including OTL/PCS, CAUI/XLAUI Lane BERT, overhead monitor/control, Tandem Connection Monitoring, capture/decode, BERT, throughput test.
General features include: CFP port compliant to MSA standards; up to two 100G modules in one UX400 can be coupled for full bidirectional testing; SCPI-based remote control and scripting commands OTN; OTN testing for OTU3 and OTU4; complete multistep mapping/multiplexing; Ethernet over OTN, ODU0 and ODUflex; service disruption measurements; tandem connection monitoring; overhead monitoring and byte decoding; payload and line through monitor modes; per-lane optical power and frequency measurements; external clock interface.
Ethernet features include: 100G and 40G Ethernet testing; Optical Lane BERT and CAUI/XLAUI Lane BERT; PCS layer testing with skew generation/monitoring; service disruption measurements; RFC2544 testing; multistream testing up to 32 independent streams; IPv4 and IPv6 traffic generation; Q-in-Q (VLAN stacking) and multiple MPLS tag support; BER testing at Layer 2 and Layer 3; smart Loop mode for Layer 2 and Layer 3; coupled operation (two modules); one-way latency measurement; line rate packet capture with Wireshark decode SDH/SONET; STM-256, OC-768, STL256.4; line rate or as OTU3 payload.